M-Clip Breakaway StapleClips (50/Box)

Pack of 50 stainless steel DF-800MC/50 M-Clip Breakaway StapleClips. Intended for outside corner application points on thermoplastic parts such as bumpers and clips. The inside corner of a broken part might not be accessible from the backside. Using the M-Clip on the front of the repair not only allows for the repair to be performed, but also saves time by not having to remove the part from the vehicle. These areas are usually right angles, bends and joints.

Breakaway StapleClips:

This small design element will cut cycle time and save technicians extra steps. The leads are notched like someone took an axe to a tree, allowing them to be snapped off with a hand, instead of having to go back with snips. The time savings does not stop there: if sunken deep enough the leads will break below the surface of the plastic eliminating the need to go back over with a grinder later. Over time these simple improvements make the difference in profitability and not going over the allocated time.

Consumable replacement part for the DF-400BR, DF-800BR, or any other Hot Stapler.